To use the Z-Raw-Data, Position List, or Acceleration List segment:
2. | Use the Motion-Law Selector to make the segment a Z-Raw-Data (or Position List, or Acceleration List) |
In the image below: there is only one segment, with an X-axis range from 0 to 360.
However, you can have more than one 'Z-Raw Data' segment, and optionally, other 'motion-law' segment also.
3. | Click the Z-Raw-Data Segment in the graph area |
4. | Open the Data-Transfer Table. |
5. | Select the top, left cell in the Data-Transfer table. |
6. | Cut & Paste data to the Data-Transfer Table from, a Graph FB Plot, NotePad®, Excel®, or an open a .txt or .asc file. The data must be as columns of data. |
In the Data-Transfer Table:
6. | Click the first (top-left cell) and SHIFT+ Click the last (bottom-right cell) 'Y–axis' cells that you want to Put to the Z-Raw-Data Motion-Law. Do not select X–axis values. |
7. | Use the 'Put List' tool - using this icon, - in the toolbar at the top of the Data-Transfer dialog-box. |
|

|
Z-Raw-Data
NEED to Check Below!!! Please Experiment.
When you Put data to a Z-Raw-Data Segment, MotionDesigner will do the following:
• | Do nothing if you post less than 5 points. But MotionDesigner will tell you to put more points in your list. |
(Remember, you must...
2. | Shift+Click the last data cell in the Data-Transfer table to 'put' to the Z-Raw Data segment) |
• | Create points to coincide with the points in the segment. |
• | Numerically Differentiate the data to create Velocity, Acceleration and Jerk values. |
• | MotionDesigner will allow you to extract your original data you Put to the Z-Raw-Data Segment by using Get List Data. |
|