... delete Constraints

<< Click to Display Table of Contents >>

Navigation:  MechDesigner Reference & User Interface > How to... and FAQs > Part Editor: How to... and FAQs > How to... >

... delete Constraints

How to delete a sketch Constraint

You cannot see Geometric-Constraints in the graphics-area.

1.SHIFT + Click a sketch-element in the graphics-area

The sketch-element AND the constraints that you have added to it show in the Selection-Window.

2.Right-click the constraint in the Selection-Window

3.Click Delete element in the shortcut menu

Note:

If a Constraint has been added to a Point (a Point, start-Point, end-Point or center-Point), then you must click the Point and not the sketch-element to see the constraint in the Selection-Window.